While this might be useful to know, the ArtCAM 2015 R2 product range is no longer supported, and no further service packs will be released for it. I'll be sure to let you know their wrote: After updating your ArtCAM Express software, please confirm if your reported issue persists. The Spiral finishing strategy is especially suitable for flat surfaces. The toolpath technique of walking in a circle along the flat surface of the center of the plate is very helpful for the evenness of the surface. I can reproduce this issue shown in your screencast, so I'll report it to the Development team for further investigation. Therefore, your first step should be to install ArtCAM Express 2015 R2.SP3 (64-bit build 860) on your computer using the instructions which I sent to your registered email address from on 12th December 2017. The virtual stage of the artistic design of the Kawung pattern at ArtCAM 2015 R2. Many thanks for reporting this issue with the Block and Rotate Copy tool in Autodesk ArtCAM Premium 2018 (Version: 2018.0.3 Build: -1912-b2886ed2a), and for sharing your screencast. The originating vector being copied is the correct length with the anchor point centered to the circle and model It doesn't matter if the circle is 3' with 3 copies 8' with 3 copies or 14' with 6 copies I still get the same results. I have an occurring problem with the rotate copy within a circle.Ĭopying a vector which goes from the center to the outside circle vectorĪll copies that are not horizontal or vertical are short of connecting to the outside circle yet the circle is the correct size as is the length of the vector.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |